- StarChip Digital LED Strip
- StarChip16 Ultra High Density APA102 2020 LED Bar
StarChip16 Ultra High Density APA102 2020 LED Bar
Teeny, Tiny, LEDs! These grain-of-sand sized LEDs are the APA102-2020 LED from APA Electronics. Measuring at only 2mm x 2mm each, we crammed 16 of them together to form this ultra-high-density LED bar that's only 1.5 wide and 3/8" thick.
Not only that, we made it modular! You can tile multiple of these bars together to make strips of varying length. Each purchase comes with a 4-pin male header and 2 VHB dots to mount the bars anywhere (VHB will take 12-24 hours to fully cure once attached). We've added power and ground pads on the back if you want to add a power capacitor. These are fully compatible with the Chippernut Shift Lights (v3 and newer).
Dimensions: 1.5" x 3/8" (39.8mm x 8.4mm)
Current Max: 960mA
** Please note: There is an input and output side. You'll want to connect the first bar to the INPUT side only. Then connect the output of the first bar to the input of the second bar, if you are linking multiple bars together. If you connect it backwards, there's a good chance you will toast the bar.
VCC 5V: 5 Volts DC In
CKI: Clock In
SDI: Data In
VCC 5V: 5 Volts DC Out
CKO: Clock Out
SDO: Data Out
GND: Ground Out
These LED bars can be VERY, VERY bright. If driven at their full potential, they can draw nearly 1 amp each. As a result, they generate heat. As LEDs do. Do not run these at full-brightness for very long, because they will get HOT. It's recommended that you keep power draw at less than 0.5 amp per board. Chippernut, LLC, it's partners, affiliates, owners, and anyone else you can think of, will not be held liable for any and all forms of injury, loss, harm, scalds, booboos, owies, squinting, tears, sunspots, or expletives resulting from use of, or proximty to, these amazing LEDs. By purchasing the StarChip16, you agree to all of the above.